0 Members and 1 Guest are viewing this topic.

AuthorTopic: Upgrading a Cisco Catalyst 3560 Switch  (Read 2949 times)

Offline aegkaluk

  • Administrator
  • Hero Member
  • *****
  • Posts: 1096
  • Total Like : 0
    • Email
« on: 16, 07, 2012, 13:57:56 »
Upgrading a Cisco Catalyst 3560 Switch
Here are my notes on upgrading a Catalyst 3560. I plugged in a laptop to the serial console and an ethernet cable into port 1 (technically interface Gigabit Ethernet 0/1). Here is the official Cisco documentation I followed. It’s for the 3550, but the Cisco support engineer said that it’s close enough.

First Hurdle: VLAN Mismatch Error
I quickly got bunch of errors that stated “Native VLAN Mismatch: discovered on Gigabit Ethernet 0/1.” The far end of the new switch is VLAN1. To fix this error, I moved port 1 from VLAN 3 to VLAN 1. These are the commands I ran.

switch>show vlan

VLAN Name Status Ports
———- ———– ————- ——————–
1 default active Gi0/28
3 server active Gi0/1, Gi0/2, Gi0/3 ….

switch> enable
switch# config term
switch (config)# interface Gi0/1
switch (config-if)# switchport access vlan 1
switch (config-if)# exit
switch (config)# exit
switch# show vlan

VLAN Name Status Ports
——— ———– ————- —————
1 default active Gi0/1, Gi0/28
3 server active Gi0/2, Gi0/3 ….

Second Hurdle: Couldn’t Reach TFTP Server
To upgrade the image, I had to put the image on a TFTP server and pull it down. Unfortunately I wasn’t able to ping my FTP server. I quickly figured out that I didn’t have an IP address for VLAN 1. To set the IP address:

switch(config)#int vlan 1
switch(config-if)# ip address
switch# ping

Finally the upgrade!
Cisco offers a .tar and a .bin image for the upgrades. Use the .tar file if you want to use the CMS software. I just wanted to use the command line interface (CLI), so I grabbed the .bin file (c3560-ipbasek9-mz.122-44.SE.bin) and placed it on the root directory of my TFTP server.

1. Verified that there’s enough space. The .bin file is ~8MB. In the 3560’s flash:

switch#dir flash

<——- Tuncated except for last line ——->
24998976 bytles total (16349184 bytes free)

Since there’s ~ 16 MB free, we’re good to go. Otherwise delete by issuing this command:

switch#delete /force /recursive flash:directory_of_old_image_here

2. Downloaded image onto the switch and verified its integrity

switch#copy tftp flash
Address or name of remote host []?
Source filename []? c3560-ipbasek9-mz.122-44.SE.bin
Destination filename [c3560-ipbasek9-mz.122-44.SE.bin]?

switch#dir flash
switch#verify flash:c3560-ipbasek9-mz.122-44.SE.bin

3. Changed the boot image in the switch

switch#show boot
switch#configure terminal
switch(config)#boot system flash:c3560-ipbasek9-mz.122-44.SE.bin
switch#show boot

4. Saved, verified, and rebooted

switch#write memory
switch#show version

Upon reboot
switch#show ver

5. Drank a celebratory drink. Coffee of course, because I was still at work.